Installing a Glass Mosaic Tile Floor

Home  »  Ceramic Tile  »  Installing a Glass Mosaic Tile Floor

Mosaic tile is beautiful and durable, and working with it is easier than ever today. Modern mosaic floor tile is available in squares that are held together by an underlayer of fabric mesh. These squares are set in much the same way as larger tile, but their flex ibility makes them slightly more diff icult to hold, place, and move. The instructions given with this project simplify the handling of these squares.

The colors of mosaic tile shift just as much as any other tile, so make sure all the boxes you buy are from the same lot and batch. Colors often vary from one box to another, too, so it’s a good idea to mix tile between boxes to make any shifts less noticeable.

It’s also important to know that adhesive made for other tile may not work with glass or specialty mosaic tile. Consult your tile retailer for advice on the right mortar or mastic for your project. Before you start, clean and prepare the floor. Measure the room and draw reference lines. Lay out sheets of tile along both the vertical and horizontal reference lines. If these lines will produce small or difficult cuts at the edges, shift them until you’re satisfied with the layout.

1. Beginning at the intersection of the horizontal and vertical lines, apply the recommended adhesive in one quadrant. Spread it outward evenly with a notched trowel. Lay down only as much adhesive as you can cover in 10 to 15 minutes.

Beginning at the intersection of the horizontal and vertical lines2. Stabilize a sheet of tile by randomly inserting three or four plastic spacers into the open joints.

Installing a Glass Mosaic Tile Floor3. Pick up diagonally opposite corners of the square and move it to the intersection of the horizontal and vertical references lines. Align the sides with the reference lines and gently press one corner into place on the adhesive. Slowly lower the opposite corner, making sure the sides remain square with the reference lines. Massage the sheet into the adhesive, being careful not to press too hard or twist the sheet out of position. Continue setting tile, filling in one square area after another.

Pick up diagonally opposite corners4. When two or three sheets are in place, lay a scrap of 2×4 wrapped in carpet across them and tap it with a rubber mallet to set the fabric mesh into the adhesive and force out any trapped air.

When two or three sheets are in place5. When you’ve tiled up close to the wall or another boundary, lay a full mosaic sheet into position and mark it for trimming. If you’ve planned well and are installing small-tile mosaics, you can often avoid cutting tiles.

tiled up close to the wall 6. If you do need to cut tiles in the mosaic sheet, and not just the backing, score the tiles with a tile cutter. Be sure the tiles are still attached to the backing. Add spacers between the individual tiles to prevent them from shifting as you score.

Add spacers between the individual 7. After you’ve scored the tiles, cut them each individually with a pair of tile nippers.

After you've scored the tiles,8. Set tile in the remaining quadrants. Let the adhesive cure according to the manufacturer’s instructions. Remove spacers with a needlenose pliers. Mix a batch of grout and fill the joints. Allow the grout to dry, according to manufacturer’s instructions.

Set tile in the remaining quadrants9. Mosaic tile has a much higher ratio of grout to tile than larger tiles do, so it is especially important to seal the grout with a quality sealer after it has cured.Mosaic tile has a much higher ratio

Leave a Reply

Your email address will not be published. Required fields are marked *